Quality dust collector filter bags manufacturer.Provide the filtration solution.

yelangseo390

Zhejiang Grace Envirotech Co. ltd (https://www.dustfilter-bag.com/s ... ant-filter-bag.html),with the famouse brand "ECOGRACE".Our commitments is to enhance and optimize the performance of dust filters for particulate air pollution control.Contact number: 86-571-86058862-8008.
What are the maintenance methods for boiler dust removal bags?
1、 Inspection
1. Check if the boiler dust removal bag is twisted or damaged.
2. Check if there is any dust deposition inside the dust removal bag of the boiler, and if necessary, clean it in a timely manner.
3. Check if the connection of the heater of the boiler dust removal bag is tight and there is no looseness.
2、 Cleaning
1. When cleaning, clean the boiler dust removal bag with clean water or neutral detergent, and do not use solvents or organic solvents.
2. The cleaning of boiler dust removal bags can be done through automatic cleaning, manual cleaning, spray cleaning, and other methods.
3. After cleaning, rinse with clean water to avoid damage to the boiler dust removal bag caused by residual cleaning agents.
3、 Repair
1. During maintenance, the length, width, and support of the boiler dust removal bag should be checked. If there is any damage, it should be repaired in a timely manner.
2. When repairing the boiler dust removal bag, a polyester cloth should be used to cover the damaged area to prevent the large pores in the damaged area from reducing the dust removal effect.
3. When repairing the boiler dust removal bag, attention should be paid to avoiding the use of organic solvents to avoid damage to the boiler dust removal bag.
4、 Replace
1. If the heat resistance, corrosion resistance, and strength of the boiler dust removal bag severely decrease, a new boiler dust removal bag should be replaced in a timely manner.
2. When replacing a new boiler dust removal bag, attention should be paid to following the correct installation method to avoid affecting the dust removal effect of the boiler.
3. When replacing the boiler dust removal bag, the inner surface of the bracket should be cleaned and disinfected to ensure the normal use of the boiler dust removal bag.